Table of Contents
Advertisement
Command Reference Guide
voice trunk-list <name>
Use the voice trunk-list command to create a permit/deny trunk list and to enter the trunk list
configuration mode. Use the no form of this command to remove the trunk list.
Additional subcommands are available once you have entered the trunk list configuration mode:
trunk <Txx>
Syntax Description
<name>
trunk <Txx>
Default Values
By default, no trunk lists are configured.
Command History
Release A2
Functional Notes
The trunk lists are permit/deny lists that operate in the same manner as automatic number identification
(ANI) lists, and are used to specify trunks that will be permitted or denied access on specified voice trunk
groups.
There is no limit on the number of trunks that can be added to the trunk list, and there is no limit on the
number of trunk lists that can be applied to a voice trunk group. The trunk lists are applied to the trunk
group in the order they are listed.
Although there is no limit on the number of trunks allowed in a trunk list, or the number of
trunk lists applied to voice trunk groups, it is important to remember that the more lists
that are applied to a trunk group, the more the runtime performance of call routing will be
affected.
Usage Examples
The following example creates a trunk list called TEST2 and specifies the trunks to be included in the list:
(config)#voice trunk-list TEST2
(config-trunk-list-TEST2)#trunk T01
(config-trunk-list-TEST2)#trunk T03
60000CRG0-35E
Specifies the name of the trunk list.
Specifies the trunk to add to the trunk list. Trunks are specified by their
2-digit identifier. For example, T01.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1451
Advertisement
Table of Contents
