ADTRAN AOS Version R10.1.0 Command Reference Manual page 1480

Command Reference Guide
stopbits <value>
Use the stopbits command to set the number of stopbits per character for a terminal session. This value
must match the configuration of your VT100 terminal or terminal emulator software. The default is
1 stopbit per character. Use the no form of this command to return to the default value.
Syntax Description
<value>
Default Values
By default, the stopbits are set to 1.
Command History
Release 1.1
Usage Examples
The following example configures 2 stopbits per character for the console terminal session:
(config)#line console 0
(config-con 0)#stopbits 2
60000CRG0-35E
Specifies the stopbits per character. Select from 1 or 2 stopbits per
character.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Line (Console) Interface Command Set
1480