Line (Ssh) Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
L (SSH) I
INE NTERFACE
To activate the Line Secure Shell (SSH) Interface Configuration mode, enter the line ssh command
specifying a SSH session(s) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line ssh 0 4
(config-ssh0-4)#
You can select a single line by entering the line ssh command followed by the line number (0-4). For
example:
>enable
#configure terminal
(config)#line ssh 2
(config-ssh2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
accounting commands begin on page 1482
authorization commands begin on page 1485
ip access-class <ipv4 acl name> in on page 1487
ip access-policy <ipv4 acp name> on page 1489
ipv6 access-class <ipv6 acl name> in on page 1491
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1493
line-timeout <value> on page 1494
login on page 1495
login authentication <listname> on page 1496
login local-userlist on page 1497
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Line (SSH) Interface Command Set

1481