Line (Console) Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
L (C
INE ONSOLE
To activate the Line (Console) Interface Configuration mode, enter the line console 0 command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line console 0
(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
accounting commands begin on page 1465
authorization commands begin on page 1468
databits <value> on page 1470
flowcontrol on page 1471
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1472
line-timeout <value> on page 1473
login on page 1474
login authentication <listname> on page 1475
login local-userlist on page 1476
parity on page 1477
password <password> on page 1478
speed <rate> on page 1479
stopbits <value> on page 1480
60000CRG0-35E
) I C
NTERFACE
Copyright © 2012 ADTRAN, Inc.

Line (Console) Interface Command Set

S
OMMAND ET
1464