Ptp Client; The "Show" Commands; Show Ptp Info - Siemens SCALANCE XM-400 Configuration Manual

System time

5.4 PTP Client

The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
Fully Qualified
Domain Name(100)
ipv6
ip6_addr
Result
The SNTP unicast server is reset to the default value.
Further notes
You configure the setting with the
You display this setting and other information with the
command.
5.4 PTP Client
The following devices support time-of-day synchronization using PTP:
● SCALANCE XR528-6M
● SCALANCE XR552-12M
This section describes commands relevant for configuration of the Precision Time Protocol
according to IEEE 1588.
5.4.1

The "show" commands

This section describes commands with which you display various settings.
5.4.1.1

show ptp info

Description
This command shows the current settings for the Precision Time Protocol (PTP).
172
Description
Keyword for an IP address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
Value for the IPv6 address of the time
server
sntp unicast-server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Enter a valid IPv4 unicast address
-
Maximum of 100 characters
-
Enter a valid IPv6 address.
command.
show sntp unicast–mode status
Configuration Manual, 06/2016, C79000-G8976-C252-11