Commands In The Interface Configuration Mode; Map Subnet - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call up the command with the following parameters:

vlan range <vlan-id(1-4094)> - <vlan-id(2-4094)>

The parameters have the following meaning:

Enter a space before and after the hyphen, e.g.

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The command prompt is as follows:

CLI(config-vlan-range)#

Configuration commands you enter with this command prompt apply to all selected VLANs.

Further notes

With the command

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.

Depending on the Interface selected, various command sets are available.

In the Global configuration mode, enter the

Commands relating to other topics that can be called in the interface configuration mode can

be found in the relevant sections.

● If you exit the Interface configuration mode with the

Global configuration mode.

● If you exit the Interface configuration mode with the

Privileged EXEC mode.

With this command, you configure IPv4 subnet-based VLAN.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Number of the addressed VLAN

, you return to the Global configuration mode.

Range of values / note

vlan range 5 - 10

command to change to this mode.

command, you return to the

command, you return to the

Network structures