Igmp Querier; Commands In The Global Configuration Mode; Ip Igmp Snooping Querier - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols

8.4 IGMP querier

Syntax
Call up the command with the following parameters:
no ip igmp snooping static-group <mcast_addr>
The parameter has the following meaning:
Parameter
static-group
mcast_addr
Result
The static IGMP entry has been deleted.
Further notes
You create a static IGMP entry with the
8.4 IGMP querier
This section describes the commands for the query functionality of the Internet Group
Management Protocol (IGMP).
8.4.1

Commands in the Global Configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.4.1.1

ip igmp snooping querier

Description
With this command, you configure the IGMP snooping switch as querier.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
468
Description
Keyword for a static entry
Value for a multicast address
ip igmp snooping static-group
configure terminal
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Enter a valid multicast address.
command to change to this mode.
or command and are then in the
end exit
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.