Ipv6 Ospf Dead-Interval - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.4.3

ipv6 ospf dead-interval

Description
With this command, you specify the time that can elapse before the neighbor router is
assumed to have "failed". This means that no more Hello packets were received from it
during this time.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf dead-interval <interval>
The parameter has the following meaning:
Parameter
interval
Result
The interval is specified.
Further notes
You display the configuration with the
You enable OSPFv3 routing with the
You can reset the interval to the default with the
604
Description
Interval in seconds
show ip ospf interface
ipv6 router ospf
Range of values / note
1 ... 65535
Default: 40
The value must be four times the hello interval.
The routers located on the same link must have the
same interval.
command.
command.
no ipv6 ospf dead-interval
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.