7.4.2.10
ipv6 dhcp client-id type
Description
With this command, you specify what forms the DUID (DHCP Unique Identifier).
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client-id type {llt | en | ll}
The parameters have the following meaning:
Parameters
llt
en
ll
Result
The DUID is specified.
Further notes
You enable DHCPv6 with the
You display the setting with the
7.4.2.11
ipv6 dhcp client-id interface
Description
With this command, you specify which IP interface uses a DUID of the type
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
DUID is based on the link local address and a time stamp
DUID is assigned by the vendor (en = enterprise number)
DUID is based on the link local address
ipv6 address dhcp
show ipv6 dhcp interface
7.4 DHCPv6 client (IPv6)
command.
command.
Network protocols
Range of values
/ note
-
-
-
or
.
llt
ll
345