Distribute Prefix - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You specify the administrative distance with the
9.7.3.3

distribute prefix

Description
This command enables the filtering of the routing information according to an IPv6 address
for incoming or outgoing routing information.
Note
This command is available only with layer 3.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
distribute prefix <ip6_addr> {in | out}
The parameters have the following meaning:
Parameter
ip6_addr
in
out
Result
Filtering is enabled.
Further notes
You disable filtering with the
You display the configured filters with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
IPv6 address
Incoming routing information is filtered.
Outgoing routing information is filtered.
no distribute prefix
command.
distance
Values
enter a valid IPv6 address
-
-
command.
command.
show ipv6 rip filter
Layer 3 functions
9.7 RIPng (IPv6)
699