No Spanning-Tree Loop-Guard - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call the command without parameters:
spanning-tree loop-guard
Result
The "Spanning Tree Loop Guard" function is enabled.
Further notes
You disable the setting with the
You can display the status of this function and other information with the following
commands:
●
show spanning-tree detail
●
show spanning-tree active detail
●
show spanning-tree interface
6.3.5.13

no spanning-tree loop-guard

Description
This function prevents alternative ports or root ports becoming designated ports if there is a
disruption of a one-way link.
With this command, you disable the function.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree loop-guard
Result
The "Spanning Tree Loop Guard" function is disabled.
268
no spanning-tree loop-guard
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.