Vrrp Preempt - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
9.5.5.7

vrrp preempt

Description
With this command, you specify that a router with higher priority can take over the master
role from a router with lower priority.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> preempt
The parameters have the following meaning:
Parameter
vrid
delay minimum
Result
The function is enabled.
Further notes
You assign IP addresses to a virtual router with the
You enable routing with VRRP3 with the
You disable the function with the
You can display the status of the function with the
interface
666
Description
ID of the virtual router
Keyword for a period of time
no vrrp preempt
command.
Range of values / note
1 ... 255
-
vrrp associated-ip
command.
router vrrp
command.
or with the
show vrrp3
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show vrrp3