Commands In The Acl Standard Configuration Mode; Permit - Siemens SCALANCE XM-400 Configuration Manual

Result
The packet filtering according to the access control list (ACL) is canceled.
Further notes
You enable the setting with the
You display the configuration of the access control list with the
11.4.4

Commands in the ACL standard configuration mode

This section describes commands that you can call up in the ACL standard configuration
mode.
In the Global configuration mode, enter the
to change to the configuration mode for this ACL. If an ACL with the specified number does
not exist, an ACL with the corresponding number is created.
Note
You can display existing access control lists with the
● If you exit the ACL standard configuration mode with the
Global configuration mode.
● If you exit the ACL standard configuration mode with the
Privileged EXEC mode.
11.4.4.1

permit

Description
With this command, you configure an IP access control list. The IP ACL contains a
description of the IP addresses for which the incoming and outgoing frames will be
forwarded.
You have the following options:
● All incoming and/or outgoing frames are forwarded.
● Incoming and/or outgoing frames of a specific host are forwarded.
● Incoming and/or outgoing frames of hosts of a specific subnet are forwarded.
● Incoming and/or outgoing frames of a specific protocol are forwarded.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
ip access-group
ip access-list standard <acl-num>
show access-lists
Security and authentication
11.4 IP access control list
command.
show access-lists
command,
command.
command, you return to the
exit
command, you return to the
end
839