Layer 2 management protocols
8.2 IGMP
8.2.2.4
no ip igmp group-list
Description
With this command, you delete a multicast group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip igmp group-list <integer>
The parameter has the following meaning:
Parameter
integer
Result
The multicast group has been deleted.
Further notes
You define a multicast group with the
You display the configured multicast groups with the
8.2.2.5
ip igmp limit
Description
With this command, you define the maximum number of multicast groups that can be
learned using IGMP on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
440
Description
Number of the multicast group
ip igmp group-list
Range of values / note
1 ... 4294967295
command.
show ip igmp group-list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.