Match Next-Hop Ipv6 - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

match next-hop ipv6

With this command, you specify whether or not the filtering for a route map will be based on

the router (IPv6) to which the routing information is sent next.

This command is available only with layer 3 (IPv6).

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Call up the command with the following parameters:

match next-hop ipv6 <next hop IPv6 address>

The parameter has the following meaning:

next-hop Ipv6 ad-

The filter for the next router (IPv6) is created.

Further notes

You delete the filter for the next router (IPv6) with the

You create a filter for the next router (IPv4) with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

IPv6 address

Range of values / note

Enter the IPv6 address of the router to which the routing infor-

mation will be sent next.

no match next-hop ipv6

match next-hop ip

show route-map

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11