Commands In The Global Configuration Mode; Ip Dhcp-Server - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
Result
The configuration of the DHCP server is displayed.
7.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.5.2.1

ip dhcp-server

Description
With this command, you enable the DHCP server on the device.
Note
To avoid conflicts with IPv4 addresses, only one device may be configured as a DHCP
server in the network.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server
Result
The DHCP server is enabled.
Further notes
You disable the DHCP server with the
348
command to change to this mode.
configure terminal
or
end exit
command.
no ip dhcp-server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command and are then in the