Syntax
Call up the command with the following parameters:
no ip dhcp server <ip address>
The parameter has the following meaning:
Parameter
ip address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP address is removed.
Further notes
You enable the DHCP Relay Agent with the
You create the IP address with the
You display the IP addresses with the
7.6.2.3
ip dhcp relay circuit-id option
Description
The Circuit ID is a sub option of the "DHCP Relay Information" option. The Circuit ID
contains information about the origin of the DHCP packet.
With this command, you specify the information contained in the Circuit ID.
The Circuit ID is encoded in the DHCP packet if the "DHCP relay information" option is
enabled.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp relay circuit-id option [router-index] [vlanid] [recv-port]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
IP address of the DHCP server
service dhcp-relay
ip dhcp server
show dhcp server
7.6 DHCPv4 Relay Agent (IPv4)
Range of values / note
Enter the IP address to be delet-
ed.
command.
command.
command.
Network protocols
369