9.4.4.9
no vrrp priority
Description
With this command, you reset the router priority back to the default value.
Note
This command is available only with layer 3.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> priority
The parameters have the following meaning:
Parameter
vrid
Result
The priority is reset.
Further notes
You configure a VRRP interface with the
You create the priority with the
You assign IPv4 addresses to a virtual router with the
You display the priority with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
ID of the virtual router
interface
command.
vrrp priority
show vrrp interface - vrid
9.4 VRRPv2 (IPv4)
Range of values / note
1 ... 255
command.
command.
vrrp associated-ip
command.
Layer 3 functions
639