Vrrp Accept-Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
Commands relating to other topics that can be called in the VRRP3 Router configuration
mode can be found in the relevant sections.
● If you exit the VRRP3 Router configuration mode with the
the Interface configuration mode.
● If you exit the VRRP3 Router configuration mode with the
Privileged EXEC mode.
9.5.5.1

vrrp accept-mode

Description
With this command, you enable the ping function for virtual IPv6 addresses on the VRRP3
interface.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> accept-mode
The parameter has the following meaning:
Parameter
vrid
Result
The ping function to virtual IPv6 addresses is enabled.
Further notes
You disable the ping function for virtual IPv6 addresses with the
command.
You assign IP addresses to a virtual router with the
You can display the status of the function with the
interface
660
Description
ID of the virtual router
command.
command, you return to
exit
command, you return to the
end
Range of values / note
1 ... 255
no vrrp accept-mode
vrrp associated-ip
or with the
show vrrp3
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show vrrp3