Ip Pim Dr-Priority - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
Requirement
● The interface is not a router port.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip pim
Result
The assignment of the interface to PIM is deleted.
Further notes
You assign an interface to PIM with the
9.10.5.5

ip pim dr-priority

Description
With this command you specify which interfaces will be candidates for the designated router
(DR).
The DR forwards the IGMP Joins to the rendezvous point.
Requirement
● The interface is not a router port.
● The DR is also the IGMP querier.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ip pim dr-priority <priority(1-4294967295)>
772
command.
ip pim
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11