Qos-Trust-Mode - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
dscp-map <dscp (0-63)> queue <queue(1-8)>
The parameters have the following meaning:
Parameter
dscp
queue
queue
The DSCP codes are assigned to the queues as follows:
DSCP codes 0 - 7 → Queue 2
DSCP codes 8 - 15 → Queue 1
DSCP codes 16 - 23 → Queue 3
DSCP codes 24 - 31 → Queue 4
DSCP codes 32 - 39 → Queue 5
DSCP codes 40 - 47 → Queue 6
DSCP codes 48 - 55 → Queue 7
DSCP codes 56 - 63 → Queue 8
Result
The assignment table for DSCP codes is configured.
10.5.3.3

qos-trust-mode

Description
With this command you can set the method according to which packets to be forwarded are
prioritized port by port.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
qos-trust-mode interface <interface-type> <interface-id > {untrust|cos|dscp|cos-dscp}
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
DSCP code
Keyword for a queue
Queue that is assigned to this DSCP
code
Load control
10.5 Service classes
Range of values / note
0 ... 63
-
1 ... 8
799