Commands In The Interface Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
The parameters have the following meaning:
Parameter
default
connected
ospf
static
route-map
name
Result
In certain cases, forwarding of routing information is disabled.
Further notes
You enable the forwarding with the
You display the setting and other information with the
9.7.4

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
Note
These commands are available only with layer 3.
704
Description
Default routes are not forwarded.
Route information of local subnets is
not forwarded.
No routes learned by OSPF are for-
warded.
No static routes are forwarded.
Keyword for a route map.
Name of the route map.
no redistribute metric
interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
-
-
-
-
Maximum of 20 characters
command.
command.
show ipv6 rip
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Configuration Manual, 06/2016, C79000-G8976-C252-11