No Standby Connection-Name; Standby Force-Master - Siemens SCALANCE XM-400 Configuration Manual

Result
The standby connection is assigned a name.
8.5.6.3

no standby connection-name

Description
With this command, you delete the name of a standby connection.
Requirement
You are in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call the command without parameters:
no standby connection-name
Result
The name of the standby connection is deleted.
8.5.6.4

standby force-master

Description
With this command, you enable the standby force-master function.
Requirement
● HRPis enabed
● You are in the Redundancy configuration mode.
The command prompt is:
cli(config-red)#
Syntax
Call the command without parameters:
standby force-master
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Layer 2 management protocols
8.5 Ring redundancy and standby connection
481