Siemens SCALANCE XM-400 Configuration Manual page 317

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ipv6 route <prefix> <prefix len>
(
[<NextHop>] {
[vlan <id> ] [<administrative distance>] [unicast] | [<short>] [unicast] |
[<interface-type> <interface-id>]
[<administrative distance>] [unicast]
})
The parameters have the following meaning:
Parameter Description
prefix
IPv6 address of the recipient
prefix len
Number of bits belonging to the prefix
(from left to right)
NextHop
IPv6 address to which the selected addresses will be forwarded.
vlan
Keyword for a VLAN connection
id
Number of the addressed VLAN
administrative
The value for the administrative distance
distance
unicast
Addressing mode unicast
short
The value for the administrative distance
interface-type
Type or speed of the interface
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry is deleted.
Further notes
You configure a static entry in the IPv6 routing table with the
You display the IPv6 routing table with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
Enter a valid IPv6 address.
1 ... 128 bits
128: The node (host) itself
Enter a valid IPv6 address.
-
1 ... 4094
0 ... 65535
Default: 1
-
0 ... 65535
Default: 1
Enter a valid interface.
ipv6 route
command.
show ipv6 route
Network protocols
7.2 IPv6 protocol
command.
317