Snmp Community Index - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.8 SNMP
Further notes
You configure the setting with the
You display the configured SNMP groups with the
You display the access configurations for SNMP groups with the
command.
You display the configured SNMP tree views with the
7.8.2.6

snmp community index

Description
With this command, you configure the details of an SNMP community.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp community index <CommunityIndex> name <CommunityName>
security <SecurityName> [context <Name>][{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
CommunityIndex
name
CommunityName
security
SecurityName
context
Name
Storage type
If optional parameters are not specified when configuring a community, the default values
apply.
396
command.
snmp access
Description
Index of the community
Keyword for the name of the communi-
ty
Name of the community
Keyword for the security name
Security name
Keyword for the context name
Context name
specifies whether the settings remain
following a restart
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
show snmp group
show snmp group access
show snmp viewtree
Range of values / note
max. 32 characters
-
max. 32 characters
-
max. 32 characters
-
max. 32 characters
•
volatile
The settings are lost after a
restart
•
nonvolatile
The settings are retained after
a restart
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
(volatile):
(non-volatile):