Auto-Summary; No Auto-Summary - Siemens SCALANCE XM-400 Configuration Manual
Simatic net industrial ethernet switches command line interface (cli)
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (832 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
9.6.3.1
auto-summary
Description
This command automatically summarizes routing information according to IP classes. When
possible, subnets are summarized according to classes (A, B or C) and entered as single
routes. As default, this function is enabled.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call the command without parameter assignment:
auto-summary
Result
Subnets are entered in the routing table summarized as class A, B or C networks.
9.6.3.2
no auto-summary
Description
This command disables the automatic summarizing of routing information.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call the command without parameter assignment:
no auto-summary
Result
Subnets are not summarized according to classes.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Layer 3 functions
9.6 RIPv2 (IPv4)
679
Advertisement
Table of Contents
