Network protocols
7.3 DHCPv4 client (IPv4)
7.3.2.3
ip dhcp client mode
Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname|pnio-name-of-station}
The parameters have the following meaning:
Parameter
mac
client-id
client-id
sysname
pnio-name-of-
station
Result
The registration mode of the DHCP client is configured.
334
Description
The client registers with its MAC ad-
dress
The client registers with the assigned
ID
Name of the assigned ID
The client registers with the assigned
system name
The client logs in with the PROFINET
name. The name is assigned with the
PST tool.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
-
max. 32 characters
-
-
Configuration Manual, 06/2016, C79000-G8976-C252-11