No Ipv6 Address Dhcp; Ipv6 Address Link-Local - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
7.2.4.5

no ipv6 address dhcp

Description
With this command, you delete the IPv6 address and disable DHCPv6.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 address dhcp
Result
DHCPv6 is disabled.
Further notes
You enable DHCPv6 with the
You configure the interface as a router port with the
You show the setting with the
You can display the statistics of the DHCPv6 client with the
statistics
7.2.4.6

ipv6 address link-local

Description
With this command, you assign a link local address to the interface.
324
ipv6 address dhcp
show ipv6 dhcp interface
command.
command.
command.
no switchport
command.
show ipv6 dhcp client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11