Further notes
You enable routing with RIP with the
9.7.1.2
show ipv6 rip filter
Description
This command shows the configured filters.
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ipv6 rip filter
Result
The configured SNMP filters are displayed.
9.7.1.3
show ipv6 rip peer-table-status
Description
This command shows the peer status information
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ipv6 rip peer-table-status
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
or
cli#
command.
ipv6 router rip
Layer 3 functions
9.7 RIPng (IPv6)
693