No Ip Rip Receive Version; Ip Rip Send Version - Siemens SCALANCE XM-400 Configuration Manual
Simatic net industrial ethernet switches command line interface (cli)
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (832 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
Layer 3 functions
9.6 RIPv2 (IPv4)
Result
It has been specified which RIP version incoming updates need to have.
9.6.4.4
no ip rip receive version
Description
This command specifies that there is no restriction relating to the version of received RIP
updates. Updates according to RIPv1 and RIPv2 are received.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameters:
no ip rip receive version
Result
All RIP updates are received.
9.6.4.5
ip rip send version
Description
This command specifies the RIP version for outgoing routing information.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
690
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Advertisement
Table of Contents
