Network protocols
7.2 IPv6 protocol
Syntax
Call up the command with the following parameters:
no ipv6 address <prefix> link-local
The parameter has the following meaning:
Parameter
prefix
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The link local address is deleted.
Further notes
You assign a link local address to an interface with the
You display this setting and other information with the
7.2.4.8
ipv6 enable
Description
With this command, you enable IPv6 on the interface. As default, IPv6 is disabled.
Requirement
● IPv6 routing is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
326
Description
Link local address
Range of values / note
Specify a valid link local address.
fe80::xxxx:xxxx:xxxx:xxxx
ipv6 address link-local
show ipv6 interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.