8.2.3.18
no ip igmp static-group
Description
With this command, you delete the assignment of a client to a static multicast group..
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip igmp static-group <Group Address> [source <Source Address>]
The parameters have the following meaning:
Parameter
Group Address
source
Source Address
Result
The client is deleted from the multicast group.
Further notes
You assign a client to a multicast group with the
You display the list of configured multicast groups with the
command.
8.2.3.19
ip igmp version
Description
This command specifies which version of IGMP will be used on an interface..
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Address of the multicast group
Keyword for a client
IP address of the client
Layer 2 management protocols
Range of values / note
-
-
-
command.
ip igmp static-group
show ip igmp group-list
8.2 IGMP
455