Network Protocols; Ipv4 Protocol; The "Show" Commands; Show Ip Route - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

This part contains the sections that describe the commands for working with the various
network protocols.
7.1

IPv4 protocol

This section describes commands of the Internet Protocol (IP) version 4.
7.1.1

The "show" commands

This section describes commands with which you display various settings.
7.1.1.1

show ip route

Description
This command shows the routes currently being used.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|ospf|static|summary}]
The parameters have the following meaning:
Parameter
ip-address
mask
connected
ospf
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
The destination address of the route.
Defines an address range using the
subnet mask.
Shows the network routes with a direct
connection.
Shows the OSPF entries in the routing
table.
Range of values / note
Enter a valid IPv4 address
/8, /16 or /24
-
-
7
285