No Pool-Enable - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
Syntax
Call the command without parameter assignment:
pool-enable
Result
The setting is enabled.
Note
If the IPv4 address band is enabled, the following parameters can no longer be edited:
• DHCP options (
• Port Range (
• Relay Agent Information (
• Static Leases (
Further notes
You display the setting with the
You disable the setting with the
7.5.3.7

no pool-enable

Description
With this command you specify that this IPv4 address band will not be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
no pool-enable
Result
The setting is disabled.
358
...)
option
)
ports
relay-information
)
static-lease
show ip dhcp-server pools
no pool-enable
)
command.
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11