Cli-Console-Timeout - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
ip
ip-address
ipv6
ip6-address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The tracing of the route is activated.
Further notes
You display the route with the
3.1.12 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.1.12.1

cli-console-timeout

Description
With this command, you enable the automatic logout and you configure the timeout setting
for the CLI.
Note
No automatic logout from the CLI
If the connection is not terminated after the set time, check the setting of the "keepalive"
function on the Telnet client. If the set interval is shorter than the configured time, the lower
value applies. You have set, for example, 300 seconds for the automatic logout and 120
seconds for the "keepalive" function. In this case, a packet is sent every 120 seconds that
keeps the connection up.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for an IPv4 address
IPv4 address of the destination
Keyword for an IPv6 address
IPv6 address of the destination
command.
show traceroute
configure terminal
end
Range of values / note
-
Enter a valid IPv4 address.
-
Enter a valid IPv6 address.
command to change to this mode.
or command and are then in the
exit
Configuration
3.1 System
81