Show Mac-Address-Table Dynamic Unicast - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

The unicast blocking settings for ports are displayed.

show mac-address-table dynamic unicast

This command shows the table with the dynamic unicast MAC addresses assigned by the

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show mac-address-table dynamic unicast[vlan<vlan-range>]

The parameters have the following meaning:

aa:aa:aa:aa:aa:aa

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

If you do not select any parameter from the parameter list, the entries are displayed for all

available interfaces.

The dynamic unicast MAC addresses are displayed.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>

<interface-id>}]

Keyword for a VLAN connection

Number of the addressed VLAN

Keyword for a MAC address

Keyword for a an interface description

Type or speed of the interface

Module no. and port no. of the interface

Layer 2 management protocols

Range of values / note

Enter a valid interface