No Vrrp Primary-Ip - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no vrrp primary-ip

With this command, you remove an IPv4 address from the virtual router.

This command is available only with layer 3.

You are in the VRRP Interface configuration mode.

The command prompt is as follows:

cli (config-vrrp-if)#

Call up the command with the following parameters:

no vrrp <vrid(1-255)> ipv4 <ucast_addr > [secondary]}]

The parameters have the following meaning:

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The IPv4 address is removed from the virtual router.

Further notes

You configure a VRRP interface with the

You assign IPv4 addresses to a virtual router with the

You display the IPv4 addresses with the

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

ID of the virtual router

Value for an IPv4 unicast address

Secondary IP addresses

show vrrp interface - vrid

9.4 VRRPv2 (IPv4)

Range of values / note

Enter a valid IPv4 unicast ad-

vrrp associated-ip

Layer 3 functions