Ip Igmp Group-List - Siemens SCALANCE XM-400 Configuration Manual

Result
IGMP is disabled.
Further notes
You enable IGMP with the
You display the setting and other information with the
command.
8.2.2.3

ip igmp group-list

Description
With this command, you define a multicast group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp group-list <integer> <ip-address> <mask>
The parameters have the following meaning:
Parameter
integer
ip-address
mask
Result
The multicast group has been created.
Further notes
You delete a multicast group with the
You display the configured multicast groups with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
ip igmp
Description
Number of the multicast group
IP address of the multicast group
Subnet mask of the multicast group
no ip igmp group-list
Layer 2 management protocols
show ip igmp global-config
Range of values / note
1 ... 4294967295
Specify the IP address.
Specify the subnet mask.
command.
show ip igmp group-list
8.2 IGMP
command.
439