No Ip Name Server - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call up the command with the following parameters:
ip name-server {ipv4 <ucast_addr> | ipv6 <ip6_addr>} [index <id(1-3)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
ipv6
ip6_addr
index
id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP address and, if specified, the index for a DNS server have been set.
7.1.2.9

no ip name server

Description
With this command, you delete required DNS server.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip name-server {ipv4 <ucast_addr> | ipv6 <ip6_addr>} [index <id(1-3)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
ipv6
ip6_addr
296
Description
Keyword for an IPv4 address
IPv4 address of the DNS server
Keyword for an IPv6 address
IPv6 address of the DNS server
Keyword for the index
Index of the DNS server
Description
Keyword for IPv4
IP address of the DNS server
Keyword for IPv6
IPv6 address of the DNS server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Enter a valid IPv4 address.
Enter a valid IPv6 address.
-
1 ... 3
Range of values / note
-
Enter a valid IPv4 address.
-
Enter a valid IPv6 address.
Configuration Manual, 06/2016, C79000-G8976-C252-11