Snmp Engineid Migrate; No Snmp Engineid Migrate - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.8 SNMP
7.8.2.8

snmp engineid migrate

Description
With this command, you enable the SNMPv3 user migration.
If the function is enabled, an SNMP engine ID is generated that can be migrated. You can
transfer configured SNMPv3 users to a different device. If you enable this function and load
the configuration of the device on another device, configured SNMPv3 users are retained.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
snmp engineid migrate
Result
The SNMPv3 user migration is enabled.
Further notes
You disable the SNMPv3 user migration with the
7.8.2.9

no snmp engineid migrate

Description
With this command, you disable the SNMPv3 user migration.
If the function is disabled, a device-specific SNMP engine ID is generated. To generate the
ID, the agent MAC address of the device is used. You cannot transfer this SNMP user
configuration to other devices.
If you load the configuration of the device on another device, all configured SNMPv3 users
are deleted.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
398
no snmp engineid migrate
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.