Match Metric-Type - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
Result
The filter for the value of the metric is deleted.
Further notes
You create a filter for the value of the metric with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.9

match metric-type

Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the type of the metric.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call up the command with the following parameters:
match metric-type {inter-area | intra-area | type-1-external | type-2-external }
The parameters have the following meaning:
Parameter
inter-area
intra-area
type-1-external
type-2-external
Result
The filter for the type of the metric is created.
720
Description
Routes learnt from different areas
Routes that originate from the same area
Routes whose path costs (metric) are made up from the
external path costs and the patch costs to the ASBR
Routes with only external path costs (metric)
command.
match metric
show route-map
Range of values / note
-
-
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
.
route-map
command.