Commands In The Global Configuration Mode; Port-Channel Load-Balance - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.2 Link aggregation
Result
The information is displayed.
6.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
6.2.2.1

port-channel load-balance

Description
With this command, you configure the load balancing policy for the interconnected ports of
the previously defined port channels.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
port-channel load-balance
{mac-src-dst | ip-mac-src-dst}
[<port-channel-index(1-8)>]
The parameters have the following meaning:
Parameter
mac-src-dst
ip-mac-src-dst
port-channel-index
If you do not enter a value for
230
configure terminal
Description
Load balancing is based on the MAC
addresses of the sources and destina-
tions.
Load balancing is based on the IP and
MAC addresses of the sources and
destinations.
Number of the port channel
port-channel-index
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command to change to this mode.
or command and are then in the
end exit
Range of values / note
Default: enabled
-
1 ... 8
, the setting is used for all port channels.
Configuration Manual, 06/2016, C79000-G8976-C252-11