Ip Igmp Snooping Static-Group; No Ip Igmp Snooping Static-Group - Siemens SCALANCE XM-400 Configuration Manual

8.3.3.1

ip igmp snooping static-group

Description
With this command, you create a static IGMP entry in the FDB.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp snooping static-group <mcast_addr> ports <interface-type> <iface_list>
The parameter has the following meaning:
Parameter
static-group
mcast_addr
ports
interface-type
iface_list
Result
The static IGMP entry has been created.
Further notes
You delete a static IGMP entry with the
8.3.3.2

no ip igmp snooping static-group

Description
With this command, you delete a static IGMP entry.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a static entry
Value for a multicast address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
no ip igmp snooping static-group
Layer 2 management protocols
8.3 IGMP snooping
Range of values / note
-
Enter a valid multicast address.
-
Enter a valid interface
command.
467