Layer 3 functions
9.2 OSPFv2 (IPv4)
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
router-id <router ip address>
The parameter has the following meaning:
Parameter
router ip address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The ID of the router is specified.
Further notes
You display the router ID and other information with the
9.2.3.26
summary-address
Description
With this command, you assign an area ID an address range. The address range is used to
group the external routes.
Note
This command is available only with layer 3.
Requirement
● The router is an area border router (ABR)
● You are in the OSPF Router configuration mode.
The command prompt is:
cli(config-ospf)#
548
Description
IP address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Enter the IP address of the router
or a value in the IP address for-
mat.
show ip ospf interface
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.