10.3.1.2
show mac-address-table aging-status
Description
This command shows whether or not MAC aging is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show mac-address-table aging-status
Result
The status of the MAC aging is displayed.
10.3.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
10.3.2.1
mac-address-table aging-time
Description
With this command, you configure the aging of a dynamically learned entry in the MAC
address list.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
command to change to this mode.
configure terminal
or
end
exit
Load control
10.3 Dynamic MAC aging
command and are then in the
789