The parameters have the following meaning:
Parameter
Group Address
Group Mask
RP address
Result
The interface is not a candidate for the rendezvous point.
Further notes
You define interface candidates for the rendezvous point (RP) with the
address
You display the interface candidates for rendezvous points with the
candidate
9.10.4.3
rp-static rp-address
Description
With this command you specify which interfaces will become static rendezvous points.
Configure the static RP on all devices of the PIM component.
Requirement
You are in the PIM configuration mode.
The command prompt is as follows:
cli(router-pim)#
Syntax
Call up the command with the following parameters:
rp-static rp-address <Group Address> <Group Mask> <IP address>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Address of the multicast group
Subnet mask that restricts the multicast
band
IP address of the interface
command.
command.
Layer 3 functions
9.10 PIM (IPv4)
Range of values / note
-
-
-
rp-candidate rp-
show ip pim rp-
767