Layer 2 management protocols
8.2 IGMP
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp query-interval <value (1-31744) seconds>
The parameters have the following meaning:
Parameter
value
seconds
Result
The interval is defined.
Further notes
You reset the interval to the default with the
You display the setting and other information with the
command.
8.2.3.12
no ip igmp query-interval
Description
With this command, you reset the time interval at which the multicast router sends IGMP
queries to the default value.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp query-interval
450
Description
Length of the interval
Specified in seconds
no ip igmp query-interval
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 31744
Default: 125
-
show ip igmp global-config
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.