No Match Destination Ip - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call up the command with the following parameters:

match destination ip <Ip address> <Net Mask>

The parameters have the following meaning:

The filter for the destination IPv4 address is created.

Further notes

You delete the filter for the destination IPv4 address with the

You create a filter for the destination IPv6 address with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

no match destination ip

With this command, you delete the filter for the destination IPv4 address.

This command is available only with layer 3 (IPv4).

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

IPv4 address

Subnet mask of the corresponding

Range of values / note

Enter the IPv4 address of the destination on which the filter-

ing is based.

Enter the subnet mask of the destination on which the filter-

ing is based.

match destination ipv6

show route-map

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

no match destination ip