Security and authentication
11.6 Management Access Control List
Result
Automatic learning is stopped and all learned entries are converted to static entries.
Further notes
You start automatic learning with the
11.6
Management Access Control List
This section describes the commands relevant for working with the management access
control list.
11.6.1
The "show" commands
This section describes commands with which you display various settings.
11.6.1.1
show authorized-managers
Description
This command shows the information about the configuration of the authorized managers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Parameter
ip-source
ip-address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
860
or
cli#
Description
Keyword for the network or host ad-
dress
Value for an IP address
command.
start
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
-
specify a valid IP address