Switchport Pvid - Siemens SCALANCE XM-400 Configuration Manual

Requirement
● The interface is configured as a promiscuous port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no switchport private-vlan mapping
Result
The configuration is deleted.
Further notes
You configure a promiscuous port with the
You display this setting and other information with the commands
show vlan
You configure the interface as a promiscuous port with the
6.1.3.20

switchport pvid

Description
With this command, you assign an interface to a VLAN and configure the port VLAN
identifier (PVID) for it. If a received frame has no VLAN tag, it has a tag added with the VLAN
ID specified here and is sent according to the switch rules for the port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport pvid <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
and
show vlan private-vlan
Description
Number of the addressed VLAN
switchport private-vlan mapping
.
switchport mode
Range of values / note
1 ... 4094
Network structures
6.1 VLAN
command.
,
show vlan port config
command.
215